Lindy Carbon Monoxide Alarm - Manual (Page 12)

I
NSTALLATION AND COMMISSIONING I
NSTALLATION AND COMMISSIONING
3
Rack
19'' installation
Caution!
Note
When installing the RMS in a rack, the additional requirements in
accordance with IEC 950 must be observed and complied with!
• Determine the position in which the RMS is to be located within the
19" rack. Observe the existing number of blanking plates for a uni-
form rack appearance.
Danger of overheating!
Allow sufficient space from built-in fans or air-conditioners to
ensure an unimpeded flow of air in the rack.
hten.
• Mount the RMS on sliding rails if possible.
This makes handling the device easier and reduces wear on the rack.
If the RMS is mounted freely suspended, hold the device horizontally
when tightening the screws and start with the two bottom screws.
• Mount the RMS in the desired position with 4 mounting screws,
washers and nuts.
3.2