Lux Products Smart Temp PSP300 Series - Manual (Page 2)

W A R N I N G S :
●
Read all instructions before using this ther-
mostat.
●
To reduce the risk of electric shock, this
product has a grounding type plug that has a
third (grounding) pin. This pin will only fit into a
grounding type power outlet. If the plug does
not fit into the outlet, contact a qualified electri-
cian to install the proper outlet. Do not change
the plug in any way.
● Do not use Outdoors.
●
Do not use in a bathroom. Never locate
where it may fall into a bathtub or other water
container.
●
Do not insert or allow foreign objects to enter
any openings as this may cause electric shock,
fire, or damage to the thermostat.
●
Do not use in areas where gasoline, paint,
flammable liquids are used or stored.
●
Space Heaters can be dangerous if used
improperly. Be sure to follow all the Warnings
and Cautions that came with the instruction
manual written by the manufacturer of the
Space Heater.
●
Avoid the use of an extension cord because
the extension cord may overheat and cause
risk of fire. However, if you have to use an
extension cord, the cord should be a 3-wire,
grounding type, with No. 14 AWG minimum
size and rated not less than 1875 Watts.
●
Use this thermostat only as described in this
manual. Any other use not recommended by
the manufacturer may cause fire, electric
shock, or injury to persons.
●
Never clean this thermostat while it is
plugged in. Turn On/Off switch to Off, pull out
of the wall, and then clean by using a rag only.
C A U T I O N S :
●
Your thermostat is protected against normal
static electric discharges. To minimize the risk
of damaging the unit in extremely dry weather,
touch a grounded metal object before touching
your thermostat.
●
Be careful not to drop the unit or disturb
electronic parts.
INSTALLATION
TOOLS REQUIRED: Small regular screwdriver
LOCATION:
●
Do not locate where air circulation is poor,
such as in a corner or an alcove; or behind an
open door.
●
Do not install it where there are unusual heat-
ing conditions, such as: in direct sunlight; near a
lamp, television, radiator, register, or fireplace;
near hot water pipes in a wall; near a stove on
the other side of the wall.
●
Do not locate in unusual cooling conditions,
such as: on a wall separating an unheated
room; or in a draft from a stairwell, door, or win-
dow.
●
Do not locate in a damp area. This can lead
to corrosion that will shorten thermostat life.
●
Do not install the unit until all construction
work and painting has been completed.
PREPARING THE UNIT
1. The PSP300 comes with (2) G13A size 1.5V
Alkaline Button Cell Batteries already installed.
These batteries power the clock only during nor-
mal operation. They also provide backup power
to retain the thermostats programs and settings
while it is not plugged into the wall. In order to
"activate" them, you must remove the black rib-
bon from between the two batteries prior to
using it. Use a small regular screwdriver to pry
open the battery holder and pull out the black
ribbon.
BACK OF UNIT
SCREWDRIVER
EXTERNAL
TEMPERATURE
SENSOR
BATTERY PANEL
RIBBON