Life Fitness 849 - Manual (Page 16)

13
• Screw the threaded end of the CABLE all the way onto the end of the shaft on the HEAD PLATE (9) and tighten jam nut
securely. See FIGURE 13.
STEP 13:
FIGURE 13
• Insert the WEIGHT STACK PIN (22) into the WEIGHT STACK as shown in FIGURE 13.
• SECURELY assemble the GUIDE ROD SUPPORT (5) to the TOWER (1) using four RH CAPS (26), two 3/8 X 2-1/2” BOLTS
(11), four 3/8” RH WASHERS (20) and two 3/8” LOW HEIGHT LOCK NUTS (17) as shown in FIGURE 13.
TIGHTEN!
20
26
17
• Slide GUIDE ROD BUSHINGS (27) into the tubes on the GUIDE ROD SUPPORT (5), slide 1” SHAFT COLLARS (25) under-
neath the GUIDE ROD BUSHINGS (27) and SECURELY tighten the set screws.
• If the HEAD PLATE (9) does not sit on top of the first WEIGHT PLATE (33), push the head plate down, insert the SELECTOR PIN
(22) and perform several repetitions on the machine. This will relax the cable system and prevent the HEAD PLATE (9) from
lifting up.
• If after completing previous step the HEAD PLATE (9) still does not sit on top of the first WEIGHT PLATE (33) or if there is
excess slack in the cable system, adjust the threaded end of the CABLE accordingly and retighten the jam nut.
11 3/8 X 2-1/2”
5
25
27
1
22
33
9