Linear DUAL 824 - Manual (Page 20)

18
✦ Each accessory sensor is packaged with its
own set of installation instructions specifi c to the
model of sensor.
✦ Refer to the sensor's instructions for details
on installing, operating, and testing of the
sensor.
✦ Following are basic instructions for installing
two popular DUAL 824 accessories: The Model
DXS-10 Wireless Remote Keypad and the Model
DXS-31 & DXS-32 Door/Window Transmitters.
DXS-10 WIRELESS KEYPAD
✦ The DXS-10 is used to remotely operate the
system.
✦ The keypad can be simply set on a table or
mounted to a fl at surface.
TABLE-TOP USE
✦ Four anti-mar pads are provided as a scratch
deterrent for the keypad.
✎ NOTE: Do not use the adhesive pads if the keypad
is going to be wall mounted.
1. Peel off the adhesive tape backing on the pads
and stick them to the back of the keypad.
✦ The wireless keypad can be used as a portable
keypad. Because of the hourly supervisory
transmissions, if the unit is taken out of range
from the Control Panel for more than eight hours,
the hardwired keypad will indicate “radio trouble”
for the wireless keypad. The keypad's sensor
number can be programmed for “non-supervised”
if required. See the “Advanced Programming”
section of this manual.
WALL MOUNT USE
✦ The wireless keypad can be wall mounted.
1. Open the keypad by inserting a small screwdriver
in one of the top slots in the keypad case. Gently
twist the screwdriver until the case pops open.
2. Attach the rear case to the wall using the two
screws provided.
✎ NOTE: For best signal transmission, the keypad
should be mounted at least three feet above
ground level.
3. Hook the top edge of the keypad case together
and snap the keypad onto the rear case.
✎ WARNING: The wireless keypad is designed for
indoor use only.
8. BASIC SENSOR INSTALLATION
CONNECT BATTERY
TO BATTERY CLIP
FROM TOP OF CASE TWIST
SCREWDRIVER BETWEEN
CASE HALVES UNTIL IT
POPS OPEN
USE THE FOUR SCRATCH
DETERRENT PADS PROVIDED
FOR TABLE-TOP USE
ATTACH REAR CASE TO WALL
WITH THE TWO SCREWS PROVIDED
MOUNT AT A CONVENIENT
LOCATION NEAR PRIMARY
ENTRY/EXIT DOOR