Lennox Hearth ELITE E36ODGPE-H - Manual (Page 7)

7 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Log placement
WarninG: LoGs Get Very Hot and
WiLL reMain Hot up to one Hour
aFter Gas suppLy is turned oFF.
HandLe onLy WHen LoGs are cooL.
turn oFF aLL eLectricity to tHe ap-
pLiance BeFore you instaLL Grate
and LoGs.
WarninG: tHis appLiance is not
Meant to Burn Wood. any atteMpt
to do so couLd cause irreparaBLe
daMaGe to your appLiance and
proVe Hazardous to your saFety.
WarninG: tHe size and position oF
tHe LoG set Was enGineered to GiVe
your appLiance a saFe, reLiaBLe
and attractiVe FLaMe pattern.
any atteMpt to use a diFFerent
LoG set in tHe FirepLace WiLL Void
tHe Warranty and WiLL resuLt in
incoMpLete coMBustion, sootinG,
and poor FLaMe QuaLity.
caution: neVer operate tHe FirepLace
WitHout tHe LaVa rocks in tHe Burner
pan. proLonGed use WitHout tHe
rock in pLace WiLL oVerHeat tHe pan
and cause tHe FirepLace to sHutoFF
autoMaticaLLy.
After verifying that the fireplace operates
properly, replace the cover and set the bottom
refractory components in place.
Use two (2) bags of lava rock to fill the bottom
of the burner tray to completely cover the burner
tube. Level the rock evenly.
Place the rear log approximately centered as
shown in Figure 7.
Place the base log approximately as shown
in Figure 8.
The remaining logs can be placed across the
rear and base log approximately as shown in
Figure 9. The exact position of these logs is
not critical. Due to the nature of an outdoor
environment, the flame will never be strictly
controlled. You may need to reposition the logs
to get the effect you find most desirable.
WarninG: LaVa rock WitHin tHe
Burner can "pop" For tHe First FeW
Fires. Wind Borne deBris May aLso
enter tHe FirepLace inexpedientLy.
in HiGH Wind conditions, operate
tHe appLiance WitH tHe screens or
doors cLosed.
Base Log
rear Log
top center Log
top Left Log
top right Log
Figure 7
Figure 8
Figure 9