Life Fitness X9i - Manual (Page 7)

Step 10
Locate the POLAR RECEIVER (#16). Slide the
FOAM ISOLATOR (#15) over the POLAR
RECEIVER. Remove the POLAR RECEIVER
JACK (G) from the tape and plug the POLAR
RECEIVER into the POLAR RECEIVER JACK.
Step 11
Locate the front and back MONOCOLUMN
COVERS (#5 & #6). With the wire positioned
on top, carefully insert the POLAR RECEIVER
(#16) between the vertical ribs located inside
the BACK MONOCOLUMN COVER (#6).
Place the BACK MONOCOLUMN COVER (#6)
over the PIVOT SHAFT (H) at the top of the
MONOCOLUMN (F).
NOTE: THE POLAR RECEIVER WIRE MUST
BE POSITIONED ON TOP WHEN INSERTED
INTO THE REAR MONOCOLUMN COVER
(#6).
REMARQUE : LE FIL DU RÉCEPTEUR POLAR DOIT ÊTRE PLACÉ SUR LE DESSUS LORS DE
L'INSERTION DANS LE CACHE ARRIÈRE DE LA COLONNE CENTRALE (Nº 6).
Step 12
Place the FRONT MONOCOLUMN COVER (#5) on the opposite side of the BACK MONOCOLUMN COVER (#6)
to cover the PIVOT SHAFT (G) and CONSOLE SUPPORT ASSEMBLY MOUNTING SCREWS. Interlock the top
tabs and use two PHILLIPS PAN HEAD SCREWS (#3) to secure the bottoms of MONOCOLUMN COVERS
together. Tighten the screws securely.
CAUTION: DO NOT OVER-TIGHTEN THE PHILLIPS PAN HEAD SCREWS (#3).
MISE EN GARDE : NE SERREZ PAS EXCESSIVEMENT LES VIS CRUCIFORMES À TÊTE CYLIN-
DRIQUE (Nº 3).
Step 13
Locate one FRONT ROCKER COVER (#13) and one BACK ROCKER COVER (#14). Position the FRONT
ROCKER COVER over the user side of the left end of the PIVOT SHAFT (H) (as shown)
making sure that it
interlocks with the MONOCOLUMN COVERS (#5 & #6). Place the BACK ROCKER COVER over the
opposite side of the left end of the PIVOT SHAFT in the same manner. Secure the covers using three
PHILLIPS PAN HEAD SCREWS (#3). Repeat the procedure reversing front and back for the user right
end of the pivot shaft.
CAUTION: DO NOT OVER-TIGHTEN THE PHILLIPS PAN HEAD SCREWS (#3).
MISE EN GARDE : NE SERREZ PAS EXCESSIVEMENT LES VIS CRUCIFORMES À TÊTE CYLIN-
DRIQUE (Nº 3).