Life Fitness Parabody 660 - Manual (Page 12)

FIGURE 15
STEP 15
• Insert two GUIDE RODS (1) into the BASE as shown on FIGURE 15. (NOTE: Lubricate GUIDE RODS (1) with silicon or teflon
spray available at most hardware stores.)
• Slide two WEIGHT STACK SPACERS (3), two 3/4” WASHERS (15), and two WEIGHT STACK CUSHIONS (8) - IN THAT
ORDER - down over the GUIDE RODS (1).
• Using EXTREME CARE slide all fifteen WEIGHT PLATES (16) down over the GUIDE RODS (1) on to the WEIGHT STACK CUSHIONS
(8). Make sure that the keyholes of the WEIGHT PLATES (16) are all facing the right way. (NOTE: If the 216101 50 LB. ADD-KIT
is purchased refer to the 216101 ASSEMBLY INSTRUCTIONS now.)
• Insert four CAP PLUGS (9) into the top and bottom ends of the GUIDE RODS (1) as shown in FIGURE 15.
• Slide the head plate assembly down over the GUIDE RODS (1) onto the weight stack.
• Attach the WEIGHT STACK LABELS (10) to the weight stack. Also slide the WEIGHT STACK PIN (7) over the HEAD PLATE
(4) as shown in FIGURE 15.
9
1
16
BASE
7
10
8
15
3
4
12
9