Lexmark X75 - Manual (Page 28)

24
Scanning was not successful
1
If you are using Windows 98, Windows Me, or Windows 2000 click
Start
Settings Control Panel. If you are using Windows XP,
click Start Control Panel Performance and Maintenance.
2 Double-click the System icon.
3
If you are using Windows 98 or Windows Me, click the Device
Manager tab. If you are using Windows 2000 or Windows XP, click
the Hardware tab, and then click the Device Manager button.
4 Look for the Other Devices category. If there are any Lexmark
devices found here, highlight them and press the Delete key.
Note: The Other Devices category appears only when
unknown devices are present. You should not delete any
Lexmark items unless they are present under the Other
Devices category.
5 Insert the CD and install the software again. Do not restart your
computer.
Edge of the copy did not print
1
Open the Lexmark All-In-One Center (see page 6).
2
From the Copy... section, make sure Auto-Detect is listed as the
Original size setting.
You software may not have been installed properly. Try the
following:
If your copy was made using the Color Copy button on the
Operator panel, try using the Lexmark All-In-One Center and
adjusting the Original size setting: