Lincoln Electric K520 UTILITY IM468-A - Manual (Page 9)

A-3 A-3
STEP 8
Tighten all eleven screws (7 inserted by the customer,
4 inserted at the factory) used to hold the Utility Cart
together.
STEP 9 (SEE FIGURE 6)
Stand the Utility Cart on its front. Slide the Rear Axle
through the mounting holes provided. Place the inside
washers, then the Wheels, then the outside washers.
Secure the wheels in place with cotter keys in the
holes provided and bend the ends to secure them in
place. Place the Utility Cart in the upright position.
FIGURE 6
STEP 10
The front casters are installed at the factory.
STEP 11 (SEE FIGURE 7)
Insert the Handle as shown. Slide it into the Front
Upright, adjusting it to a comfortable position. Secure
the handle using the two 1/4-20 x 1.50 screws by
aligning the hole in the end of the handle with one set
of holes in the Front Upright, and sliding the screws
through the holes. Secure the screws with one lock-
washer and one nut on each screw.
FIGURE 7
The Utility Cart is now fully assembled. Refer to the
following instructions for mounting your specific
welder to the Utility Cart.