Lantronix UBOX 2100 - Manual (Page 56)

7: Troubleshooting
UBox User Guide 56
Figure 7-3. Resetting the UBox 4100
3. Using the paper clip, quickly press the reset button inside the hole. The UBox
resets.
Figure 7-4. Resetting the UBox 2100
Rebooting the UBox into Safe Mode Using the Reset Button
If you have made an unwanted change to the UBox settings and can no longer
access the UBox, you can boot it into a “safe mode.” In this mode, the UBox reboots
using default settings (e.g., multi-user connect mode or default IP mode) and allows
you to view and edit the settings.
To boot into safe mode:
1. Press and hold the reset button until the lights turn off (this takes 3 or more
seconds). It takes approximately 15 seconds to complete the reset.
2. In the Lantronix UBox application, make sure that your Local UDP Port is 10010.
Reset Button
Reset Button