Linak TECHLINE LA35 - Manual (Page 12)

12
I/O Specifi cations: Motor
I/O Specifi cations: Potential free signal switches
Item Specifi cation Comment
Description Permanent magnet DC motor, available in
12V or 24V
Input Voltage 12VDC, +/- 20%
24VDC, +/- 10% Cable dimension 2 x 2,5 mm 2
(2 x AWG14)
Current consumption 12V, 2-10A depending on load
24V, 1-5A depending on load See curves for typical values
Speed regulations The motor can run with PWM regulation.
This could be used for soft start/stop etc. The version with “PLC option” cannot be
operated with PWN
Connection To extend actuator:
Connect Brown to positive
Connect Blue to negative
To retract actuator:
Connect Brown to negative
Connect Blue to positive
See fi gure 1 + 2 + 3 + 4
Use cable 0367002-XXXX
Actuator direction can be operated with
double-throw switch with middle position
“off”
LINAK Code: TR-1939.3314-00
Item Specifi cation Comment
Description The actuator can be equipped with two separate
micro switches that that are activated when the
actuator is fully retracted (IN) or fully extended
(OUT). The micro switches are Normally Open
Input Voltage 10-28VDC Cable dimension 6 x 0,5mm 2
(6 x AWG20)
Output voltage Same as input voltage
Switching capacity Minimum 10 mA
Maximum 1 A
Connection Supply: Red (Pin 2)
Actuator retracted: Yellow (Pin 5)
Actuator extended: Green (Pin 6) See fi gure 2 + 3 + 4
Use cable 0367003-XXXX
Combinations The potential free switches can be combined
with relative or absolute feedback. But cannot be
combined with “PLC/option” 35xxxxx1xxxxxx