Linak TECHLINE LA35 - Manual (Page 14)

14
I/O Specifi cations: PLC-option
Item Specifi cation Comment
Description Easy to use interface, with
integrated power electronics (Hbridge)
for direct PLC connection.
Soft start of the actuator. See fi gure 5
Power supply
Input Voltage 12 V DC, +/- 20 %
24 V DC, +/- 10 % Cable dimension 2 x 2,5 mm 2
(2 x AWG14)
Current consumption 12 V, 2-10 A depending on load
24 V, 1-5 A depending on load Recommended fuse:
12V version = 20A fuse
24V version = 10A fuse
Inputs: Signals to the Actuator
Outwards direction Extends the Actuator
FW – Red (Pin 2) PNP
Inwards direction Retracts the Actuator
BW – Black (Pin 1) PNP
On/Off voltages On voltage (High):
> 67 % of the power supply
Off voltage (Low):
< 33 % of the power supply
Examples on 24 V version:
On if the voltage is higher than 16 V
Off if the voltage is lower than 8 V
Input Impedance 10 K ohm
Input current < 10 mA
Outputs: Signals from Actuator
Actuator fully
retracted (IN) Signal when end stop switch in retracted
position is activated
IN = Yellow (Pin 5) Max. 50 mA switching capacity
Actuator fully
extended (OUT) Signal when end stop switch in extended
position is activated
OUT = Green (Pin 6) Max. 50 mA switching capacity
Actuator ready When the Actuator is ready the signal
is High
Ready = White (Pin 3) Max. 10 mA switching capacity
Current cut-off 12 V version: 17 - 21 A
Current cut-off 24 V version: 8.5 - 10.5 A
Output voltage Typical: Input voltage -1 V Example on 24 V version:
Output voltage on IN = 23 V (+/-0.5V)
Output voltage on OUT = 23 V (+/-0.5V)
Output voltage on READY = 23 V (+/-0.5V)
Relative
positioning For functional description see I/O
Specifi cations for Relative
positioning. Max. 12mm switching capacity
35xxxxx2Hxxxxx
Absolute
positioning For functional description see I/O
Specifi cations for Absolute
positioning.
35xxxxx2Axxxxx
Connection See fi gure 5
Use cables 0367002-XXXX and 0367003-XXXX
35 2A
35 2H
See fi gur g g e 5