LG AR702TS - Manual (Page 24)

24
2. Press AUTO CAL..
"Audyssey 2EQ", “AUTO CAL. : START” and
“AUTO CAL. : 1ST-P” flash in the display window
in turn.
3. Press ENTER.
- “FL TESTING..” appears in the display window.
- The speaker setup function is automatically
measured in the first position from each speaker.
FL TESTING..→C TESTING..→FR TESTING..→
SR TESTING..→SC TESTING..→SL TESTING..
→SW TESTING..
- After completed, the “B 2nd-POS CAL.”
appears in the display window.
Notes
• If each speaker is not connected, “CONNECT
SPK” flashes in the display window.
• If the speaker setup microphone is not
connected, “CONNECT MIC” appears in the
display window.
4. Measure a second position (recommended) or
calculate results for first position only.
Select “B 2nd-POS CAL.” or “2nd-POS BCAL.”
by pressing b/B.
“B 2nd-POS CAL.”: (Recommended) Selecting this
option will measure a second
listening position for each
speaker and will produce the
best correction results. Please
place the microphone at ear
height in a secondary listening
position, such as in a seat next
to the first one that was
measured.
“2nd-POS BCAL.”: Selecting this option will
proceed with the calculation
using the first listening position
measurement only.
5. Select ENTER.
If you select the “B 2nd-POS CAL.”, the audyssey
2EQ automatic speaker setup is measured on the
second position. After completed, “CALIBRATING...”
appears for about 2 minutes in the display window.
If you select the “2nd-POS BCAL.”, “CALIBRATING...”
appears for about 2 minutes in the display window.
6. Check the result value of speaker size, level,
distance and X-OVER by pressing b/B/v v / V V ,
ENTER.
You can only check the result values of the first
position.
Notes
• If the result values of subwoofer is “NONE”, the
FRONT LR of SPK TYPE on the SETUP menu
are automatically set to “LARGE”.
• The result values of the second position is not
measured the result value of speaker size, level,
distance and X-OVER but an optimum sound.
7. When “RESULTB B NO OK” appears in the
display window, select the “RESULT NOB B OK”
by pressing b b /B B and then select ENTER.
- The unit will automatically enter the Standby
mode.
- Selecting "RESULTB B NO OK" will restart the
Audyssey 2EQ Automatic Speaker Setup. The
previous measurements will be discarded.
8. Turn Audyssey 2EQ On or Off.
- Press AUTO CAL. on the remote control to turn
Audyssey 2EQ acoustical correction on or off.
Notes
• Press AUTO CAL. for about 2 seconds to begin the
Audyssey 2EQ automatic speaker setup again.
• If you want to cancel during the automatic speaker
setup process, press AUTO CAL. The “EXIT? > No
Yes” appears in the display window. Then select
“YES” by pressing b/B and then press ENTER.
• If there is excessive noise during automatic speaker
setup. “SPK NOISE” appears in the display window.
Quiet the environment and begin the Audyssey 2EQ
automatic speaker setup again.
• Disconnect the speaker setup microphone after
automatic speaker setup.