Setup – Lexicon MC-12 Digital Controller Lexicon MC-12 User Manual

Page 77

Advertising
background image

TRIGGER OUTPUTS

MAIN AUDIO OU

3

1

2

3

4

MICROPHONE INPUTS

LFE

SETUP

MC-12

3-35

Step A: Connecting the Microphones

• The microphones included in the Lexicon Microphone Kit

require careful handling. Dropping or otherwise physically
abusing the microphones might cause errors during use or
irreparable damage to the microphone.

• Never make or break microphone input connections unless

the MC-12 is powered off with the rear panel power switch
OR standby mode is activated with the front panel or remote
control standby button.

CAUTION

MC-12 Rear Panel

Note the following:

•

Automatic calibration requires the microphones included in the
Lexicon Microphone Kit available at authorized Lexicon dealers.
Performing automatic calibration with other microphones will
produce unknown results.

•

Proper microphone placement is essential to achieving the
desired automatic calibration results. Pay particular attention to
the microphone placement instructions and illustrations
included in this section.

•

It is important to read and observe the care and handling
documentation included with the Lexicon Microphone Kit to
ensure optimal microphone performance.

A-1. Make sure the MC-12 is powered off with the rear panel

power switch OR standby mode is activated with the front
panel or remote control standby button.

A-2. Connect the microphones included in the Lexicon

Microphone Kit to the microphone input connectors on the
MC-12 rear panel shown above. Make sure the microphone
cable plug is fully inserted for a solid connection.

During the microphone check, the microphones will be
referred to as 1, 2, 3, and 4 based on the input connector to
which the microphone is connected. It is recommended to
label the microphones for troubleshooting purposes.

A-3. Power on the MC-12 with the rear panel power switch OR

deactivate standby mode with the front panel or remote
control standby button.

Advertising