Lenovo THINKSTATION 4105 - Manual (Page 52)

Command Function
+MS=? Displays a list of supported Select Modulation options
+MS=a,b,c,e,f Select modulation where: a=0, 1, 2, 3, 9, 10, 11, 12, 56, 64,
69; b=0-1; c=300-56000; d=300- 56000; e=0-1; and f=0-1.
A, b, c,d, e, f default=12, 1, 300, 56000, 0, 0. Parameter “a”
specifies the modulation protocol desired where: 0=V.21,
1=V.22, 2=V.22bis, 3=V.23, 9=V.32, 10=V.32bis, 11=V.34,
12=V.90,K56Flex,V.34......,56=K 56Flex, V.90,V.34......,
64=Bell 103, and 69=Bell 212. Parameter “b” specifies
automode operations where: 0=automode disabled, 1=
automode enabled with V.8/V.32 Annex A. Parameter “c”
specifies the minimum connection data rate (300- 56000).
Parameter “d” specifies the maximum connection rate
(300-56000); Parameter “e” specifies the codec type (0=
Law, and 1=A-Law). Parameter “f” specifies “robbed bit”
signaling detection (0=detection disabled 1=detection
enabled)
MNP/V.42/V.42bis/V.44 commands
Command Function
%C_ %C0 Disable MNP Class 5 and V.42bis data compression
%C1 Enable MNP Class 5 data compression only
%C2 Enable V.42bis data compression only
%C3 Enable MNP Class 5 and V.42bis data compression
&Q_ &Q0 Direct data link only (same as \N1)
&Q5 V.42 data link with fallback options
&Q6 Normal data link only (same as \N0)
+DS44=0, 0 Disable V.44
+DS44=3, 0 Enable V.44
+DS44? Current values
+DS44=? List of support values
Fax Class 1 commands
+FAE=n Data/Fax Auto Answer
+FCLASS=n Service Class
+FRH=n Receive data with HDLC framing
+FRM=n Receive data
+FRS=n Receive silence
+FTH=n Transmit data with HDLC framing
+FTM=n Transmit data
+FTS=n Stop transmission and wait
46 ThinkStation User Guide