Lenovo TS100 User Manual
Hardware maintenance manual
Advertising
Table of contents
Document Outline
- Contents
- Safety
- Chapter 1. Introduction
- Chapter 2. Configuration information and instructions
- Updating the firmware
- Configuring the server
- Using the Configuration/Setup Utility program
- Using the ThinkServer EasyStartup DVD
- Using the mini-baseboard management controller utility programs
- Using the mini-baseboard management controller setup utility program
- Using the mini-baseboard management controller configuration utility program
- Using the mini-baseboard management controller firmware updates utility program
- Using the mini-baseboard management controller SDR/FRU update utility program
- Using the Boot Menu program
- Enabling the Broadcom NetXtreme Gigabit Ethernet Boot Agent
- Configuring the Broadcom NetXtreme Gigabit Ethernet controller
- LSI Configuration Utility program
- Setting up a Remote Supervisor Adapter II SlimLine
- Chapter 3. Parts listing, ThinkServer TS100 Machine Types 6431, 6432, 6433, and 6434
- Chapter 4. Removing and replacing server components
- Installation guidelines
- Connecting the cables
- Removing and replacing self-service CRUs
- Removing the side cover
- Installing the side cover
- Removing the lower bezel
- Installing the lower bezel
- Removing the upper bezel
- Installing the upper bezel
- Removing an adapter
- Installing an adapter
- Removing and installing internal drives
- Removing a hot-swap power supply
- Installing a hot-swap power supply
- Removing a memory module
- Installing a memory module
- Removing and replacing optional-service CRUs
- Removing the battery
- Installing the battery
- Removing the rear system fan
- Installing the rear system fan
- Removing the hard disk drive fan assembly
- Installing the hard disk drive fan assembly
- Removing the simple-swap backplate
- Installing the simple-swap backplate
- Removing the SAS/SATA hard disk drive backplane
- Installing the SAS/SATA hard disk drive backplane
- Removing the front-panel assembly
- Installing the front-panel assembly
- Removing the front USB connector assembly
- Removing the rear adapter retention bracket
- Installing the rear adapter retention bracket
- Removing the front adapter-retention bracket
- Installing the front adapter-retention bracket
- Installing the front USB connector assembly
- Removing the hot-swap power supply cage
- Installing the hot-swap power supply cage
- Removing the mini-SAS/SATA controller
- Installing the SAS/SATA controller
- Removing the optional mini-PCI-X enablement card
- Installing the optional mini-PCI-X enablement card
- Removing the RAID-MR10i SAS/SATA controller
- Installing the RAID-MR10i SAS/SATA controller
- Removing an IBM Remote Supervisor Adapter II SlimLine adapter
- Installing an IBM Remote Supervisor Adapter II SlimLine adapter
- Removing and replacing FRUs
- Chapter 5. Diagnostics
- Diagnostic tools
- POST
- Checkout procedure
- Troubleshooting tables
- CD or DVD drive problems
- Diskette drive problems
- General problems
- Hard disk drive problems
- Intermittent problems
- Keyboard, mouse, or pointing-device problems
- Memory problems
- Microprocessor problems
- Monitor or video problems
- Optional-device problems
- Power problems
- Serial port problems
- EasyStartup problems
- Software problems
- Universal Serial Bus (USB) port problems
- Error LEDs
- Power supply LEDs
- Diagnostic programs and messages
- Updating (flash-update) the BIOS code on the server
- Recovering from a BIOS update failure
- System-error log messages
- Solving SAS problems
- Solving power problems
- Solving Ethernet controller problems
- Solving undetermined problems
- Problem determination tips
- Appendix A. Getting help and technical assistance
- Appendix B. Notices
- Trademarks
- Important notes
- Waste electrical and electronic equipment (WEEE) notices
- Battery return program
- Electronic emissions notices
- Federal Communications Commission (FCC) statement
- Industry Canada Class A emission compliance statement
- Avis de conformité à la réglementation d'Industrie Canada
- Australia and New Zealand Class A statement
- United Kingdom telecommunications safety requirement
- European Union EMC Directive conformance statement
- German Class A compliance statement
- Japanese Voluntary Control Council for Interference (VCCI) statement
- Taiwanese Class A warning statement
- Chinese Class A warning statement
- Korean Class A warning statement
- Index