Removing an adapter – Lenovo TS100 User Manual
Page 86
Removing an adapter
To remove an adapter, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
2. Turn off the server and all attached devices; then, disconnect all power cords
and external cables.
3. Unlock and remove the side cover (see “Removing the side cover” on page 62).
4. Disconnect any cables to the adapter or any cables that impede access to the
adapter.
5. If you are removing a full-length adapter, press on the retaining tab on the left
side of the front adapter-retention bracket until the release lever on the right
side of the bracket clicks into place.
6. Remove the expansion-slot screw at the rear of the adapter.
7. Carefully grasp the adapter by its top edge or upper corners, and pull the
adapter from the server.
Attention:
Expansion-slot covers must be installed in all empty slots. This
maintains the electronic emissions standards of the server and ensures proper
ventilation of server components.
1
Retention clip
4
Adapter
68
ThinkServer TS100 Types 6431, 6432, 6433, and 6434: Hardware Maintenance Manual