Lenovo TS100 - Manual (Page 47)

3. Select Servers from the Brand list.
4. From Family list, select ThinkServer TS100, and click Continue.
5. Click Downloads and drivers to download firmware updates.
6. From the BMC software, copy the file fsloader.exe to an SDR/FRU update
diskette.
To start the mini-baseboard management controller SDR/FRU update utility
program, complete the following steps:
1. Turn on the server.
2. Insert the SDR/FRU update diskette into the diskette drive.
3. From a command line, type fsloader -? and press Enter.
Using the mini-baseboard management controller management utility
program: Use the mini-baseboard management controller management utility
program to remotely manage and configure a server network. The following features
are available from the program:
v IPMI (Intelligent Platform Management Interface) Shell
Use this feature to remotely perform power-management and system
identification control functions over a LAN or serial port interface from a
command-line interface. Use this feature also to remotely view the event log.
v Serial over LAN Proxy
Use this feature to remotely perform control and management functions over a
Serial over LAN network. Use this feature also to remotely view and change the
BIOS settings.
To download the utility program and create the mini-baseboard management
controller management utility CD, complete the following steps.
Note: Changes are made periodically to the Lenovo Web site. The actual
procedure might vary slightly from what is described in this document.
1. Go to: http://www.lenovo.com/support.
2. Enter your product number (machine type and model number) or select
Servers from the Select your product list.
3. Select Servers from the Brand list.
4. From Family list, select ThinkServer TS100, and click Continue.
5. Click Downloads and drivers to download firmware updates.
6. From the BMC software, use the information on the CD to install and use the
program.
Using the Boot Menu program
The Boot Menu program is a built in, menu-driven configuration program that you
can use to temporarily redefine the first startup device without changing settings in
the Configuration/Setup Utility program.
To use the Boot Menu program, complete the following steps:
1. Restart the server.
2. Press F12.
3. Select the startup device.
The next time the server is started, it returns to the startup sequence that is set in
the Configuration/Setup Utility program.
Chapter 2. Configuration information and instructions 29