Lenovo 6528 User Manual
Installation and user guide
Advertising
Table of contents
Document Outline
- Contents
- Safety
- Chapter 1. Introduction
- Chapter 2. Server setup roadmap
- Chapter 3. What is included with your server
- Chapter 4. Server controls, LEDs, and power
- Chapter 5. Installing and replacing optional devices
- Installation guidelines
- Server components
- Removing the side cover
- Installing the side cover
- Removing the two-piece bezel
- Installing the lower bezel
- Installing the upper bezel
- Removing a memory module
- Installing a memory module
- Removing and installing internal drives
- Removing a DVD drive
- Installing a DVD drive
- Removing a tape drive
- Installing a tape drive
- Removing a hot-swap hard disk drive
- IDs for hot-swap hard disk drives
- Installing a hot-swap hard disk drive
- Removing a simple-swap hard disk drive
- Installing a simple-swap hard disk drive
- Power and signal cables for internal drives
- Removing an adapter
- Installing an adapter
- Removing a PCI card
- Installing a PCI card
- Removing a USB embedded hypervisor flash device
- Installing a USB embedded hypervisor flash device
- Removing the virtual media key
- Installing the virtual media key
- Removing a hot-swap power supply
- Installing a hot-swap power supply
- Installing a security rope clip
- Completing the installation
- Connecting external devices
- Chapter 6. Installing and replacing customer replaceable units
- Removing the rear system fan
- Installing the rear system fan
- Removing the hard disk drive fan assembly
- Installing the hard disk drive fan assembly
- Removing the simple-swap backplate
- Installing the simple-swap backplate
- Removing the SAS/SATA hard disk drive backplane
- Installing the SAS/SATA hard disk drive backplane
- Removing the front-panel assembly
- Installing the front-panel assembly
- Removing the front USB connector assembly
- Installing the front USB connector assembly
- Removing the rear adapter retention bracket
- Installing the rear adapter retention bracket
- Removing the front adapter-retention bracket
- Installing the front adapter-retention bracket
- Removing the hot-swap power supply cage
- Installing the hot-swap power supply cage
- Removing the battery
- Installing the battery
- Removing and replacing FRUs
- Removing a ServeRAID BR10-il controller
- Installing a ServeRAID BR10-il controller
- Removing an optional ServeRAID-MR10i SAS/SATA controller
- Installing an optional ServeRAID-MR10i SAS/SATA controller
- Removing an optional ServeRAID-MR10is VAULT SAS/SATA controller
- Installing an optional ServeRAID-MR10is VAULT SAS/SATA Controller
- Removing a non-hot-swap power supply
- Installing a non-hot-swap power supply
- Removing the microprocessor and fan sink
- Installing a microprocessor and fan sink
- Removing the system board
- Installing the system board
- Chapter 7. Configuring the server
- Using the Setup Utility
- Using the Boot Manager program
- RAID controllers
- Using the ThinkServer EasyStartup program
- Enabling the Broadcom Gigabit Ethernet Utility program
- Configuring the Gigabit Ethernet controller
- Updating the firmware
- Starting the backup server firmware
- Using the Integrated Management Module
- Using the remote presence capability and blue-screen capture
- Advanced Settings Utility program
- Installing ThinkServer EasyManage software
- Chapter 8. Troubleshooting
- Troubleshooting tables
- DVD drive problems
- General problems
- Hard disk drive problems
- Intermittent problems
- Keyboard, mouse, or pointing-device problems
- Memory problems
- Microprocessor problems
- Monitor problems
- Optional-device problems
- Power problems
- Serial port problems
- Software problems
- Universal Serial Bus (USB) port problems
- Solving power problems
- Solving Ethernet controller problems
- Solving undetermined problems
- Event logs
- System-event log
- POST error codes
- Integrated management module error messages
- Diagnostic programs, messages, and error codes
- Troubleshooting tables
- Appendix A. Getting help and technical assistance
- Appendix B. Notices
- Trademarks
- Important notes
- Product recycling and disposal
- Particulate contamination
- Compliance with Republic of Turkey Directive on the Restriction of Hazardous Substances
- Recycling statements for Japan
- Battery return program
- German Ordinance for Work gloss statement
- Electronic emission notices
- Federal Communications Commission (FCC) statement
- Industry Canada Class A emission compliance statement
- Avis de conformité à la réglementation d′Industrie Canada
- Australia and New Zealand Class A statement
- United Kingdom telecommunications safety requirement
- European Union EMC Directive conformance statement
- Germany Class A compliance statement
- Japan Voluntary Control Council for Interference (VCCI) statement
- Taiwan Class A warning statement
- People′s Republic of China Class A warning statement
- Korea Class A warning statement
- Index