Installing a hot-swap hard disk drive – Lenovo 6528 User Manual
Page 67
Table 13. IDs of the hot-swap drives (models with four drive bays)
Drive bay
ID
4
0
5
1
6
2
7
3
Installing a hot-swap hard disk drive
This procedure applies only to server models that have hot-swap hard disk drives.
Before you install a hot-swap hard disk drive, read the following information:
v
The hot-swap drives must be either all SAS hard disk drives or all SATA hard
disk drives; the two types cannot be combined.
v
Inspect the drive tray for signs of damage.
v
To maintain proper system cooling, do not operate the server for more than 10
minutes without either a drive or a filler panel installed in each drive bay.
v
You do not have to turn off the server to install hot-swap drives in the hot-swap
drive bays.
v
See “Removing and installing internal drives” on page 43 for additional
information.
To install a hot-swap hard disk drive (based on your model), complete the following
steps.
Chapter 5. Installing and replacing optional devices
51