Lenovo 6528 - Manual (Page 130)

password has access to only the limited Setup Utility menu; the user can set,
change, and delete the power-on password, if the system administrator has given
the user that authority.
Power-on password
If a power-on password is set, when you turn on the server, the system startup will
not be completed until you type the power-on password. You can use any
combination of up to seven characters (A - Z, a - z, and - 9) for the password.
If you forget the power-on password, you can regain access to the server in the
following way:
v If an administrator password is set, type the administrator password at the
password prompt. Start the Setup utility and reset the power-on password.
Administrator password
An administrator password is intended to be used by a system administrator; it
limits access to the full Setup utility menu. You can use any combination of up to
seven characters (A - Z, a - z, and 0 - 9) for the password.
Using the Boot Manager program
The Boot Manager program is a built-in, menu-driven configuration utility program
that you can use to temporarily redefine the first startup device without changing
settings in the Setup utility.
To use the Boot Manager program, complete the following steps:
1. Turn off the server.
2. Restart the server.
3. When the prompt <F12> Select Boot Device is displayed, press F12. If a
bootable USB mass storage device is installed, a submenu item (USB
Key/Disk) is displayed.
4. Use the Up arrow and Down arrow keys to select an item from the Boot
Selection Menu and press Enter.
The next time the server starts, it returns to the startup sequence that is set in the
Setup utility.
114 ThinkServer TS200 Types 6522, 6523, 6524, 6525, 6526, 6528, 6529, and 6530: Installation and User Guide