Removing a non-hot-swap power supply, Removing a non-hot-swap power – Lenovo 6528 User Manual
Page 112
2
PCI slot
5. Press the ServeRAID-MR10is adapter firmly into the connector on the system
board.
6. Reconnect the cables to the new ServeRAID-MR10is adapter. Make sure that
the ServeRAID-MR10is SAS/SATA adapter is cabled.
7. Rotate the rear adapter-retention bracket to the closed (locked) position.
8. Install the side cover (see “Installing the side cover” on page 33).
9. Lock the side cover.
10. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
Removing a non-hot-swap power supply
This procedure applies only to server models that have a non-hot-swap power
supply. See “Removing the hot-swap power supply cage” on page 87 for
information about the removal of a hot-swap power supply.
When you remove or install a non-hot-swap power supply, observe the following
precautions.
Statement 8:
CAUTION:
Never remove the cover on a power supply or any part that has the following
label attached.
Hazardous voltage, current, and energy levels are present inside any
component that has this label attached. There are no serviceable parts inside
these components. If you suspect a problem with one of these parts, contact
a service technician.
96
ThinkServer TS200 Types 6522, 6523, 6524, 6525, 6526, 6528, 6529, and 6530: Installation and User Guide