Lenovo 6528 - Manual (Page 86)

Reinstalling the side cover
If you removed the side cover, reinstall it.
Note: The rear adapter-retention bracket rests against the server side cover. You
might find it easier to lay the server on its side to replace the side cover.
To reinstall the side cover, complete the following steps:
1. Make sure that all cables, adapters, and other components are installed and
seated correctly and that you have not left loose tools or parts inside the server.
Also, make sure that all internal cables are correctly routed.
Note: The cover-release latch 1 must be in the unlocked (opened) position
before you install the side cover.
2. Position the lip on the bottom edge of the side cover on the ledge on the bottom
of the chassis; then, rotate the cover up to the chassis, and then press down on
the cover release latch and push the cover completely closed until it latches
securely into place.
3. Press down on the cover-release latch and close the cover to secure it in place.
4. Lock 2 the side cover.
Note: When you lock the server side cover, it locks both the cover and the
bezel.
70 ThinkServer TS200 Types 6522, 6523, 6524, 6525, 6526, 6528, 6529, and 6530: Installation and User Guide