Removing the system board – Lenovo 6528 User Manual
Page 120
Removing the system board
To remove the system board, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
2. Turn off the server and all attached devices; then, disconnect all power cords
and external cables.
3. Turn the server on its side so that it is lying flat, with the cover facing up.
4. Unlock and remove the side cover (see “Removing the side cover” on page
5. Note where each cable is connected; then, disconnect all cables from the
system board.
6. Press and hold the drive cage release tab; then, rotate the drive cage out of
the chassis until the retaining tab on top of the cage locks into place.
7. Remove any of the following components (in addition to others that might not
be listed) that are installed on the system board and put them in a safe,
static-protective place:
v
Adapters (see “Removing an adapter” on page 55).
v
SAS/SATA controller (see “Removing a ServeRAID BR10-il controller” on
page 91).
v
Virtual media key (see “Removing the virtual media key” on page 62).
v
Microprocessor and fan sink (see “Removing the microprocessor and fan
sink” on page 99).
v
DIMMs (see “Removing a memory module” on page 37).
v
Battery (see “Installing the battery” on page 89).
v
SAS/SATA controller (see “Removing a ServeRAID BR10-il controller” on
page 91 ).
v
Hypervisor key (see “Removing a USB embedded hypervisor flash device”
on page 61).
v
The fan connector covers.
8. Remove the four screws that secure the fan sink retention module and fan sink
mounting bracket to the system board; then, set the fan sink retention module,
fan sink mounting bracket, and screws aside for use later.
Note: Make sure that you observe the orientation of the fan sink retention
module before you move it so that when you reinstall it, you install it in the
same orientation.
104
ThinkServer TS200 Types 6522, 6523, 6524, 6525, 6526, 6528, 6529, and 6530: Installation and User Guide