Lenovo 6528 - Manual (Page 95)

1 Retaining tab
2 Drive cage release tab
3 Locating pins
4 Simple-swap backplate
5 Retaining latch
11. Lift the simple-swap backplate out of the lower lip on the drive cage and set it
aside.
12. If you are instructed to return the simple-swap backplate, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Installing the simple-swap backplate
This procedure applies only to server models with the simple-swap SATA backplate
installed on the back of the hard disk drive cage.
To install the simple-swap backplate, complete the following steps.
1. Position the bottom edge of the simple-swap backplate on the lower lip of the
drive cage.
Chapter 6. Installing and replacing customer replaceable units 79