LG BH100 - Manual (Page 18)

18
Language Menu
Display Menu Language
Select a language for the Setup menu and on-
screen display.
Disc Menu / Audio / Subtitle Language
Select the language you prefer for the audio track
(disc audio), subtitles, and the disc menu.
Original – Refers to the original language in
which the disc was recorded.
Other – To select another language, press num-
ber buttons then ENTER to enter the correspon-
ding 4-digit number according to the language
code list on page 26. If you make a mistake
while entering a number, press CLEAR repeat-
edly to delete numbers one by one then correct
it.
Off (for Disc Subtitle) – Turn off Subtitle.
Audio Menu
Each DVD disc has a variety of audio output
options. Set the player’s Audio options according to
the type of audio system you use.
SPDIF (Digital Audio Output)
Bitstream – Select [Bitstream] if you connect
this unit’s DIGITAL OUT jack to an A/V Receiver
or other equipment with a Dolby Digital, DTS or
MPEG decoder.
PCM (for Dolby Digital / MPEG / DTS) – Select
when connected to a two-channel digital stereo
amplifier. DVDs encoded in Dolby Digital, DTS or
MPEG will be automatically downmixed to two-
channel PCM audio.
Notes:
•
With digital audio connection, Disc Menu button
sounds may not be heard if the [SPDIF] option is
set to [Bitstream]. (BD-ROM)
• In Bitstream mode, this player does not support
DTS-HD audio on some HD DVD and abnormal
audio will output from audio out jack. To listen to
the DTS-HD audio, you must set the [SPDIF]
option to [PCM].
• On Bitstream mode, MPEG audio on DVD will
output with PCM.
Sampling Freq. (Frequency)
If your A/V Receiver or Amplifier is NOT capable of
handling 96 kHz signals, select 48 kHz. When this
choice is made, this unit automatically converts any
96 kHz signals to 48 kHz so your system can
decode them.
If your A/V Receiver or Amplifier is capable of
handling 96 kHz signals, select 96 kHz.
Check the documentation for your A/V Receiver or
Amplifier to verify its capabilities.
Speaker Out
To select various parameters for the analog 5.1
channel output.
2CH – When a 2 channel stereo system is con-
nected to this player.
5.1CH – When a 5.1 channel surround system is
connected to this player.
5.1 Speaker Setting
The 5.1 Speaker Setting option is only available
when the [Speaker Out] option is set to [5.1CH].
Select speaker settings, including speaker size, or
test the speaker settings.
Speaker settings are only active on the Analog Multi-
Channel Output. (See [5.1 Speaker Settings] on the
next page.)
BH100-N-AA1ULL-ENG 4/6/07 12:02 PM Page 18