Life Fitness M051-00K62-A107 User Manual
Page 8
1.2
S
ETUP
Read the Operation Manual before setting up the Life Fitness Fit Stride Total Body Trainer.
W
HERE TO
P
LACE THE
L
IFE
F
ITNESS
®
T
OTAL
B
ODY
T
RAINER
Following all safety instructions in Section 1.1, move the Life Fitness Fit Stride Total Body
Trainer to the location in which it will be used. See Section 7, titled Specifications, for the dimen-
sions of the footprint. Allow one foot of clearance in front of the Life Fitness Fit Stride Total Body
Trainer to allow for movement of the pedal levers. It should be easy to mount the Life Fitness Fit
Stride Total Body Trainer from the side.
H
OW TO
S
TABILIZE THE
L
IFE
F
ITNESS
T
OTAL
B
ODY
T
RAINER
After placing the Life Fitness Total Body Trainer in position, check the unit’s stability by attempting to
rock it. Any slight rocking indicates that the unit must be leveled. Check the front stabilizing feet to
determine which foot does not rest fully on the floor. Rotate the foot counter-clockwise to lower it.
Recheck the stability and adjust again as needed until the Life Fitness Total Body Trainer is stable
and no longer rocks. Lock the adjustment into position by tightening the jam nut against the
stabilizer bar with an open end 17mm wrench.
.
C
HECK FOR
P
OWER
The console is powered by a rechargeable 6-volt battery. Check the battery by pressing the START key.
The console should light up, and the MESSAGE CENTER should display a prompt to set up a workout. If
this does not occur, mount the Life Fitness Total Body Trainer and begin pedaling. The console should
then light up, making it possible to program a workout. Pedal for 10 to 20 minutes at 1.5 mph (2.4 km/h)
or faster during a workout to charge the battery. Afterwards, the pedal action during workouts keeps the
battery charged. If the console still does not light, contact Life Fitness Customer Service. See section 6.5,
titled How to Obtain Product Service, for more information.
F
ITNESS AND
E
NTERTAINMENT
N
ETWORKING
Two interchangeable network ports allow the Life Fitness Total Body Trainer to be connected to a fit-
ness entertainment system and/or a network, such as FitLinxx
TM
interactive fitness network.
•
Fitness network: The network connection enables the console to upload user workout sta-
tistics to a fitness network database or to download remotely stored information, such a pre-
set workout program. See Section 4.2, titled Using the Workouts, for information on logging
onto a network.
•
Entertainment: The network connection enables the console to power a third-party receiver
for use with a service such as the Cardio Theater
®
entertainment system or the
BroadcastVision
TM
entertainment system.
These ports are located on the back of the console and are enclosed by a removable cover. Any use of
the ports for other than their intended purpose could void the product warranty.
7