La Crosse Technology WS-7078TWC - Manual (Page 20)

20
1. Using the Table Stand
a. The indoor weather station comes with the table stand already
mounted. If you wish to use the table-stand all that is required
is to place the indoor weather station in an appropriate
location.
2. WALL MOUNTING
a. Remove the table-stand. To do this, pull down on the stand
from the rear and rotate forward.
b. Fix a screw (not included) into the desired wall, leaving
approximately 3/16 of an inch (5mm) extended from the wall.
c. Place the indoor weather station onto the screw using the
hanging hole on the backside. Gently pull the indoor weather
station down to lock the screw into place.
TROUBLESHOOTING
Problem: No reception of WWVB time signal.
Solution: 1) Wait overnight for signal.
2) Be sure indoor weather station is at least 6 feet from any electrical
devices, such as televisions, computers, or other radio-controlled
clocks.
3) Remove batteries for five minutes, reinsert and leave the unit alone
overnight without pressing buttons.
4) If there are still problems, contact La Crosse Technology
Problem: Hour is incorrect (minute and date are correct)
Solution: Be sure correct time zone and daylight saving time are selected.
Problem: The LCD is faint
Solution: 1) Set the LCD contrast to a higher number
2) Replace batteries
Problem: No outdoor temperature is displayed.
Solution: 1) Remove all batteries, reinsert into remote thermo/hygro sensor first,
then indoor weather station.