LG LX-M150 - Manual (Page 10)

10
3.Operation
Setting the Clock
1. Press CLOCK.
(If the clock requires setting, press and hold
CLOCK for more than 2 seconds.)
- The hours begin to flash.
2. Select a 12 hour cycle or 24 hour cycle by
pressing TUNING (+/ -) on the front panel.
3. Press SET to confirm the selected hour cycle.
4. Use TUNING (+/-) buttons to set the
correct hours on the front panel.
5. Press SET.
6. Use TUNING (+/-) buttons to set the
correct minutes on the front panel.
7. Press SET and the correct time is shown on
the display.
8. Press CLOCK at any time to display the time
for about 3 seconds.
ote
The unit can also set the clock function in power
off state.
Sleep Function
When the sleep timer is used, the power is auto-
matically turned off after the specified time has
elapsed.
1. To specify the time delay before the
power is turned off, press SLEEP.
In the display window you can see
for about 5 seconds.
This means that the system turns off
automatically after 90 minutes.
Each time the button is pressed the time
interval before it turns off is reduced by
10 minutes. i.e. 80...70... etc.
Select the desired time to turn off.
2. To check the remaining time until the
power is turned off.
While the sleep function is active press
SLEEP briefly. The time remaining until it
turns off is displayed for about 5 seconds.
ote
If you press SLEEP while the sleep time is dis-
played, the SLEEP time is reset.
To cancel the sleep timer mode
If you wish to stop the function, press the SLEEP
button repeatedly until “SLEEP 10” appears, and
then press SLEEP once again while “SLEEP 10”
is displayed.
(12HR) (24HR) or
AP_LX-M150A(ENG) 3/2/06 9:54 PM Page 10