Life Fitness 97T1 User Manual
Page 48
T
ENSIONING AN
E
XISTING
S
TRIDING
B
ELT
1.
Enter the MANUAL workout and operate the treadmill for five minutes at 5.0 mph (8.0 kph).
Note: DO NOT RUN OR WALK ON BELT.
2.
Reduce the speed to 2.0 mph (3.2 kph). Walk on the treadmill. Tightly grip the handrails and apply force with feet on
the striding belt near the motor cover against the moving belt direction. If the belt slips, continue to Step 3. If it does
not slip, the tension is correct.
3.
Using the STOP key, stop the treadmill. Turn the belt tensioning bolts a quarter-turn clockwise for each side.
4.
Repeat STEPS 2 and 3 until the belt no longer slips. Do not exceed one full turn (four quarter turns) per side when
adjusting the belt tensioning bolts.
5.
Enter the MANUAL workout, and operate the treadmill at 2.0 mph (3.2 kph) and check to insure proper tracking. If the
striding belt drifts to the left or right see Tracking (Centering) A Striding Belt on the previous page.
Do not over-tighten the tensioning bolts while making belt adjustments. Over-tightening of bolts may over stretch and
damage the striding belt or roller bearings. Do not exceed one full turn of either bolt in either direction.
6.7
P
ROACTIVE
B
ELT
W
EAR
N
OTIFICATION
The treadmill proactively notifies the facility manager about belt wear through diagnostics. A single indicator is lit on the
treadmill console (if manager-enabled) when a belt check is required. This indicator light is located in the upper left corner
of the workout profile window.
•
Automatic belt check reminder at 30,000 miles (48,000 km)
•
Notification based on “Unable to Attain Target Speed” errors for specific user weights/speeds.
T
O CHECK FOR NOTIFICATIONS
:
To enter Belt/Deck Info, press and hold the PAUSE key and press the CLEAR key twice. Continue to hold down the
PAUSE key until the MESSAGE CENTER displays the words “SERVICE MENU”. Use the TIME UP and DOWN
arrow keys to navigate to the INFORMATION Menu. Then access the “Belt/Deck Information” submenu.
Note: Notifications are automatically cleared once they have been displayed.
6.8 H
OW TO
O
BTAIN
P
RODUCT
S
ERVICE
/
S
ERIAL
N
UMBER
L
OCATION
1.
Verify the symptom and review the operating instructions.
The problem may be unfamiliarity with the product and its
features and workouts.
2.
Locate and write down the serial number of the unit which is
located on the back of the unit near the toe guard as well as
under the left rear endcap.
3.
Contact LIfe Fitness Customer Support Services.
Remove plastic shroud to find large serial label location.
Small Serial Label
Large Serial Label
47