Life Fitness Multi Adjustable Bench - Manual (Page 7)

1. Attach the REAR SUPPORT (1) to the SEAT FRAME (2) using two M10 x
25mm BOLTS (3), four 3/8" SAE WASHERS (4), and two M10 NYLOCK
NUTS (5) as shown. Tighten all BOLTS and NUTS securely.
2. Attach the SEAT PAD (6) to the SEAT FRAME (2) using one M10 x 35mm
BOLT (7), one M10 x 70mm BOLT (8) and two 3/8" SAE WASHERS (4).
Attach the LUMBAR PAD (9) to the SEAT FRAME using two M10 x 95mm
BOLTS (10) and one 3/8" SAE WASHERS (4). Attach the BACK PAD (11)
to the SEAT FRAME using three M10 x 35mm BOLTS (7), and three 3/8"
SAE WASHERS (4). Tighten all BOLTS securely.
3. Adjust the bench to its highest incline position. Attach the RUBBER PAD
(12) to the SEAT FRAME (2) using four M5 x 12mm SCREWS (13) and
four #10 FLAT WASHERS (14). Tighten all SCREWS securely.
4. Install 1" HOLE PLUGS (16) into all open bolt holes.