Lightwave Communications LDX-3232 - Manual (Page 49)

R E M O T E O P E R A T I O N
Error Messages
04_06 LDX-3232 33
C H A P T E R
3
(up to 10 may be stored). Reading the error queue via GPIB clears the error
queue.
Table 3.4 Error Code Classifications
Table 3.5 LDX-3232 Series Error Codes
Error Code Range Area of Operation
E-001 to E-099 Internal Program Errors
E-100 to E-199 Parser Errors
E-200 to E-299 Execution Control Errors
E-300 to E-399 GPIB Errors
E-500 to E-599 LASER Control Errors
Error Code Explanation
E-001 Memory allocation failure
E-103 <DEFINITE LENGTH ARBITRARY BLOCK PROGRAM DATA> length too long
E-104 <NON-DECIMAL NUMERIC PROGRAM DATA> type not defined
E-105 <DECIMAL PROGRAM DATA> exponent not valid
E-106 <DECIMAL PROGRAM DATA> digit expected
E-123 Command not found
E-124 <program mnemonic> Lookup, failed because query/command type match failed
E-126 Too few or too many program data elements
E-201 <PROGRAM DATA> value out of range
E-202 <PROGRAM DATA> will not convert to valid type
E-203 Security violation, command is not available without clearance
E-205 <PROGRAM DATA> is not a Boolean value or word
E-207 <PROGRAM DATA> will not convert to an unsigned 16-bit value
E-209 <PROGRAM DATA> will not convert to an unsigned 32-bit value
E-210 <PROGRAM DATA> will not convert to a floating point value
E-211 <PROGRAM DATA> will not convert to a character value
E-213 <PROGRAM DATA> is incorrect block data length
E-214 <PROGRAM DATA> length exceeds maximum
E-302 Query error; device was addressed to talk, but GPIB controller failed to read all of the
<RESPONSE MESSAGE>