LG DP889 - Manual (Page 8)

8
Power connections
Connecting the Power Cable
Connect the supplied power cable from the unit to a power socket.
AC adapter
• This AC adapter operates on 100-120V~ 1A 50/60Hz.
• Contact an electrical parts distributor for assistance in selecting a suitable
AC plug adapter or AC cord set.
• Manufactured by NANJING WANLIDA TECHNOLOGY CO., LTD
Connect the Automotive adapter
This unit and its automotive adapter are designed for use in vehicles that have
8.5-16 volt, negative ground electrical systems. This is standard for most vehi-
cles. If your vehicle has a different type of electrical system, the DC power sys-
tem cannot be used.
Automotive adapter
• This automotive adapter operates on DC 8.5-16V.
• Contact an electrical parts distributor for assistance in selecting a suitable
automotive adapter.
• Manufactured by NANJING WANLIDA TECHNOLOGY CO., LTD.
Caution
• To prevent electrical shock and possible damage to your unit or vehicle,
always unplug the automotive adapter from the cigarette lighter socket
before you remove the plug from your unit.
• A 3 amp. 250V fuse for protection is installed in the automotive adapter.
• While the engine is being started, disconnect the automotive adapter from
the car’s cigarette lighter socket.
• Do not operate your unit when the car battery is discharged.
Peak current from the car generator may cause the DC fuse to blow.
• If the vehicle’s supply voltage drops below approximately 10 volts, your unit
may not work properly.
• Do not leave your unit in a place where the temperature exceeds 70°C
(158°F), or the pick-up device may be damaged.
Examples include:
- Inside a car with the windows closed and in direct sunshine.
- Near a heating appliance.
Plug into the
“DC 12V IN” jack.
Plug into the
“DC 12V IN”
jack.
Plug into the car’s
cigarette lighter
socket. Attach the power plug to the body of the AC adapter.
(The actual set may differ from the drawing.)
Power cord
release knob
Plug into
a power
source.
DP392-N_AUSALLK_ENG 6/2/08 12:00 PM Page 8