Lowrance electronic 540c Baja User Manual

Page 31

Advertising
background image

23

NOTE:

Throughout this manual, we will use the term MMC, but just re-
member that your unit can use an MMC or SD card to store data.

Both of these solid-state flash memory devices are about the size of a

postage stamp. An SD card is slightly thicker than an MMC. As this

manual went to press, MMCs and SD cards were available in various

storage capacities up to 2 gigabytes.
Additional MMC cards are available from LEI Extras; see ordering in-

formation inside the back cover of this manual. MMCs and SD cards

are also available at many camera and consumer electronics stores.
The MMC slot is located in a compartment on the front of the case. The

compartment door is located at the lower right corner. The following

figure shows a close-up with the door opened.

Memory card compartment with a 16 MB MMC card installed.

To remove an MMC
1. Open the card compartment door by unscrewing the thumb screw.

The screw should only be finger tight. If it was over-tightened, use a

thumbnail, a coin or a screwdriver to open the door.
2. Just press a finger against the label of the MMC and drag it from the slot.
3. Close the compartment door and fasten the thumbnail screw finger

tight.
To add an MMC or SD Card
1. Open the card compartment door.
2. Grasp the bottom of the MMC and push the top of the card into the

slot. Once the card is started, use your fingernails to slide it the rest of

the way to the left, until it is firmly seated in the slot.
3. Close the compartment door and fasten the thumb screw finger tight.

Insert card face up,

this way

Thumb

screw

Advertising