LG DX0002TM - Manual (Page 33)

H O W TO U S E H O W TO U S E
CUSTOM PROGRAM
If you have a special combination of settings that
you use frequently, you can save these settings
as a CUSTOM PROGRAM.
* To Save a Custom Program:
Turn on the dryer and turn the cycle selector
knob to select the desired cycle.
Use the cycle setting buttons to adjust the
settings for that cycle.
Press the cycle option button(s) for the option
you would like to add. A confirmation message
will be shown in the display.
Press and hold the CUSTOM PROGRAM button
for 3 seconds. 1
2
3
4
CUSTOM PGM
*PGM SAVE
To Recall a Custom Program:
Turn on the dryer.
Press the CUSTOM PROGRAM button.
Press the START/PAUSE button to start
the cycle.
1
2
3
NOTE: You may only save one custom
program at a time. Pressing and holding the
CUSTOM PROGRAM button will overwrite
any previously saved custom program.
MAX
STEAM FUNCTIONS
1
2
3
4
To Fill the Steam Feeder
Pull out the drawer.
Lift out the steam feeder.
Fill the steam feeder to MAX with water.
Place the steam feeder in the drawer; then
push in the drawer until it clicks into place.
Water
ONLY
Steam
Feeder Drawer
w WARNING:
• Do not fill the steam feeder with liquids such as gasoline, dry-cleaning solvents, or other flammable or explosive
substances. They give off vapors that could explode.
• Do not fill the steam feeder with hot water (over 86°F/30°C).
• Do not drink water from the steam feeder.
IMPORTANT NOTES ABOUT STEAM CYCLES
Before using a Steam Cycle, the steam feeder must be filled with water up to the
MAX line. If not, an Error message or ADD WATER will be displayed. Make sure that
the steam feeder is filled with water and the drawer is completely closed. Turn the
dryer off then restart the Steam Cycle.
• Only use water. Do not fill the steam feeder with foreign substances, rinse agents, or detergents.
• Before moving the dryer, make sure the steam feeder is empty.
• Do not use distilled water; the water level sensor in the steam generator will not work.
• Be careful to put the Steam Feeder otherwise water will be overflow.
• Wipe up any spilled water around the Steam Feeder and the drawer before starting the dryer.
REFRESH
MID
HIGH HIGH
0:08 EST. TIME
REMAINING
ADD WATER
20%
ERROR
WATER SUPPLY ERROR.
FILL STEAM FEEDER
WITH FILTERED WATER.
SEE OWNERS MANUAL.
33