Lucent Technologies CELLPIPE 7820-0766-004 User Manual
Page 13
Setup
Connecting CellPipe 20 Series products
CellPipe™ 20 Series User’s Guide
2-3
Figure 2-2. CellPipe 20 Series rear panels
To connect up the CellPipe 20 Series units, proceed as follows:
1
LAN connections:
•
On the CellPipe 20A-GX, use the provided Ethernet cable (yellow) to
connect the ETHERNET port to the NIC on a computer or to an appropriate
networking component.
•
On the CellPipe 20S, use the provided Ethernet cables to connect the four
LAN ports (1X, 2X, 3X, 4X) to NICs on computers or to appropriate
networking components.
2
WAN connections:
•
Use the blue WAN cable to connect the WAN port to a wall xDSL connector
set up by your service provider.
3
Connect the power cable and power up the unit.
Note:
Apply power last. Doing so turns on the unit, which does not have a power
switch.
CellPipe 20A-GX
CellPipe 20S