LSI 20860 - Manual (Page 16)

1-8 Using the LSI20860
1.3.1 Internal SCSI Bus Connections
This section provides step-by-step instructions about making internal
SCSI bus connections.
Step 1. To connect an internal SCSI device, plug the 50-pin connector
on one end of the SCSI ribbon cable into the connector J2 (see
Figure 1.3 ). The ribbon cable included in your LSI20860 kit is
keyed to ensure it is connected correctly.
Step 2. Plug the 50-pin connector on the other end of the SCSI ribbon
cable into the SCSI connector on your internal SCSI device.
Step 3. To attach more than one internal device, use an internal SCSI
ribbon cable with the required number of 50-pin connectors
attached along its length. Plug the cable connectors into the
internal SCSI device connectors, as illustrated in
Figure 1.3 .
Step 4. Terminate the SCSI bus as described in the Section 1.3.3,
“SCSI Bus Termination,” page 1-10 .
Step 5. Make any required power connections to your internal SCSI
device(s).