Lumens Technology PS600 - Manual (Page 13)

Chapter 4 Installation
4.1 Setup the Digital Visualizer
1. Pull up the arm. Adjust the position and height (the height should
be 48.5 cm for operation) of the arm by moving the 3-section joint
2. Turning the camera head toward the platform
※ Note：The angle of the camera head is limited. Don’t turn it
forcefully when it reaches the maximal angle
4.2 Powering on the Digital Visualizer
※ Note：Before using the Digital Presenter, make sure that you have
connected it to the computer, video source or other output devices.
See Figure: 3-3, Rear View for the position of connector jack.
1. Connect the power cable to the AC IN jack
2. Press (the Power button) for about 1 second to power on the
Digital Presenter. The red LED (flashing until the presenter is
started) turns to green
English - 12