Liebert Power Strips - Manual (Page 4)

4
C
ONFIGURATION WITH
L
IEBERT
MP A
DVANCED
A
CCESS
S
ERVER
M
AKE
C
ONNECTIONS
1. Connect power to the Liebert MP Advanced Access Server and turn the unit On (the On/Off switch is
on the rear of the unit; some units do not have this switch; they are energized whenever their power
cord is plugged into a power source).
2. Attach the adapter (RS-232 to RJ-45) to one end of a silver configuration cable (included) and connect
that end of the cable to a COM port on a computer. Connect the other end of the cable to the EIA-232
port of the MP-DS62 card on your MP Advanced Access Server.
3. Plug one end of the second silver RJ-45 cable into any of the ports in the MP-DS74 module in your
Liebert MP Advanced Access Server; plug the other end of the cable into the EIA-232 port on your MP
Advanced Power Strip.
E
STABLISH
C
OMMUNICATION
W
ITH
C
ARD
1. Use terminal emulation software, such as HyperTerminal™, to open a
direct connection to the MP-DS62 card. Use the settings at right. Press
Enter for the Main Menu, choose “C” and then “1” to configure the
MP-DS62 port.
2. Enter “8” for Network Port Configuration (below left), then “7,” then “N”
to disable DHCP (below right).
1 2 3 4
CX3
CX4
EIA-232 EIA-232 I/0 MODULE NETWORK INTERFACE ETHERNET
ROUTE LINE
DS74
MADE IN USA
100-240VAC
??????????
0.21-0.12AMPS
DS62 CX1
CX2
POWER 1
2
3
4
5
6
8
8
EIA-232
On/Off Switch
(not on all
models)
EIA-232 Port - Connect
to Power Strip EIA-232 Port
Ethernet Port
MP-DS74 Card With
Configurable
Communication Ports
Liebert MP Advanced
Power Strip
(MP-C5120)
Liebert MP Advanced
Access Server
(MP-S5138)
EIA-232 Port
Mounting
Bracket on
either side
Baud Rate: 9600
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: N/A
HYPERTERMINAL SETTINGS
Enter “N”
to disable
DHCP
Enter “7”
to change
DHCP setting
Choose “8” to change
Network Port
Configuration