Windows me installation – Lindy 70536 User Manual

Page 10

Advertising
background image

- 10 -

SiI 3112 Controller.

4.7. Windows ME installation

1. Power off the system. Insert Combo Card into an available PCI slot. Power up the

system.

2. During the system boot up, the Hardware Wizard will display that it found 'PCI standard

PCI-to-PCI bridge', select 'Automatic search for a better driver (Recommended)',

click 'Next'. Then click 'Finish' to exit the wizard.

3. The Hardware wizard will display that it found 'PCI Universal Serial Bus'. Select

'Automatic search for a better driver (Recommended)', insert diskette driver into

Floppy drives, and click 'Next', then click 'Finish' to exit the wizard.

4. The Hardware W izard will display that it found a 'PCI Raid Controller', select

'Automatic search for a better driver (Recommended)'. Click 'Next'.

5. System will go through the enumeration process and install the driver. At the end of the

process, click 'Finish' to complete the installation. Reboot the system if your

W indows ME drive is connected on the SiI 3112 Controller.

4.8.Verifying The installation under Windows 98SE and ME

Follow the instructions in this section to verify that the controller was installed

correctly.

1. Right click on 'My Computer' icon, select 'Properties', left click on 'Device Manager'

tab.

2. Double click on 'System devices', then left click on 'PCI standard PCI-to-PCI bridge'. If

there is no yellow '!' or '?' in front of 'PCI standard PCI-to-PCI bridge' the driver has

started correctly.

3. Double click 'Universal Serial Bus Controllers', If there is no yellow '!' or '?' in front of

NEC PCI to USB Enhanced Host Controller

NEC USB Open Host controller

NEC USB Open Host controller

USB Root Hub

USB Root Hub

The driver has started correctly.

4. Double click on 'SCSI Controllers', If there is no yellow '!' or '?' in front of 'Silicon

Image SiI 3112 SATARaid Controller', the driver has started correctly.

5. To view information about the devices attached to the controller, right click the

'Devices' and select Properties from the context menu, then select the tab labeled

Advertising