How to... install the lifelink upgrade kit – Life Fitness 9100HR User Manual
Page 2
Continued
Life Fitness Model 9100HR (REV 1 & REV 2)
Treadmill
How To... INSTALL THE LIFELINK UPGRADE KIT
STEP 10:
Loosen but do not remove the two screws at the bottom of the PC CONTROL BOARD assembly. Pop open the two
plastic rivets at the top of the assembly with a standard screwdriver. Swing down the top of the PC CONTROL BOARD
and lift the entire assembly away from the frame.
(REV 1 ONLY)
STEP 11:
Ensure the grounding strap is still on your wrist and clipped to the
frame.
NOTE: THE ORIENTATION OF E-PROMS BY THE U-NOTCH.
Remove andreplace the two CPU E-PROMS supplied in the upgrade
kit, one at a time.
NOTE: INSERT THE E-PROM MARKED “CONTROL” INTO U4
AND THE E-PROM MARKED “LOGIC” INTO U7.
STEP 12
Plug in and route the CABLE HARNESS supplied in the upgrade kit from the NETWORK BOARD to the PC
CONTROL BOARD at CONNECTOR P8. Secure the HARNESS away from moving parts using the tie wraps supplied
in the upgrade kit.
STEP 13
Reverse steps 7, 8 and 10 to return the PC CONTROL BOARD ASSEMBLY, front cover and front protector shield
back to their proper positions.
STEP 14
Plug the STUB CABLE supplied in the upgrade kit into the NETWORK BOARD and then feed it through the hole on
the FRONT PROTECTOR SHIELD. Punch out one of the holes on the userright side of the MOTOR COVER and feed
the STUB CABLE through it. Replace the MOTOR COVER making sure not to over-tighten the four screws in the
RUBBER MOUNTS. Take the other end of the STUB CABLE and plug it into the T-CONNECTOR on the backbone.
STEP 15
Plug the unit in at the wall outlet and turn the power on at the ON/OFF switch. A blue box will appear on the
LIFECENTER SCREEN stating “INSTALLING NODE” and will disappear in approximately 30 seconds.
CAUTION: DO NOT TURN OFF THE POWER OR DISCONNECT THE NETWORK DURING THIS TIME.
DOING SO BEFORE THE “INSTALLING NODE” MESSAGE DISAPPEARS MAY DEACTIVATE
THE NETWORK BOARD.
Should you require any assistance with this Technical Information , please direct all inquiries to:
Customer Support Services
10601 West Belmont Avenue