La Crosse Technology Radio Controlled Projection Alarm WT-5600 - Manual (Page 13)

13
TROUBLESHOOTING
Problem:
The Projection is faint
Solution: 1) Change intensity setting
2) Use AC adapter
3) Darken surroundings
4) Use fresh batteries (if AC is not used)
Problem: The LCD is faint.
Solution: 1) Replace the batteries.
Problem: No reception of WWVB signal.
Solution: 1) It may help reception to face the front of the Projection alarm
in the general direction of Ft. Collins, Colorado.
2) Wait overnight for signal.
3) Be sure the Projection alarm is at least 6 feet from any
electrical devices, i.e. TV sets, computers, or other radio
controlled clocks.
4) Remove batteries for five minutes, reinsert and leave the unit
alone overnight without pressing buttons.
5) If problems persist contact La Crosse Technology.
Problem: Hour is incorrect (minute and date are correct).
Solution: 1) Be sure correct time zone and daylight saving time are
selected.
Note: For any questions not answered, please contact La Crosse Technology’s Technical
Support with the contact information found at the end of this instructional manual.
SPECIFICATIONS FOR WT-5720
Power source:
AC Adapter (included)
Input: 120VAC/60Hz Output: DC 6V/100MA
Battery type: Station: 2 x AA, 1.5V (Alkaline) (optional)
Battery life: Approximately 12 months, depending on
projection and light use
Dimensions (L x W x H): 5.25”W x 3.75”H x 1.25”L