Linksys VOICE SYSTEM SPA 900 SERIES - Manual (Page 97)

4-10
Linksys IP Phone Administrator Guide
Firmware Version 5.1
Chapter 4 SPA900 Series LCD Command Reference
9 Network
9.1 DCHP
Shortcut: Setup, 9, edit, y/n, ok
When DHCP is enabled, the phone obtains its IP address from a DHCP server.
To view DHCP status, press the Setupbutton and press 9, or scroll down to the Network option and press
the select soft key. The displays shows 1 DHCP Enable with a Yes or No to indicate the current status.
To enable or disable DHCP, press the edit soft key and press the y/n soft key to toggle between Yes and
No. After making the selection, press the ok button and the display returns to the Network menu.
9.2 Current IP Address
Shortcut: Setup, 9, 2 save
To view the current IP address, press 2 on the Network menu, or scroll down until Current IP Address
is highlighted and press the select soft key. The Current IP Address is set in one of the following ways:
• Receive the address from a DHCP server by enabling DHCP (Option 9.1)
• Manually set the address using the Non DHCP IP Address option (Option 9.8)
9.3 Host Name
Shortcut: Setup, 9, 3 save
The Host Name is set by the administrator. The user cannot change the setting.To view the Host Name,
press 3 from the Network menu, or scroll down to Host Name and press the select soft key.
9.4 Domain
Shortcut: Setup, 9, 4 save
The Domain Name displays the name of the domain in which the phone is operating and is not user
configurable. To view the Domain, press 4 from the Network menu, or scroll down to highlight Domain
and press select.
9.5 Current NetMask
Shortcut: Setup, 9, 5 save
To view the Current NetMask, press 5 from the Network menu, or scroll down to highlight NetMask
and press the select soft key. The Current NetMask is set in one of the following ways:
• Receive the address from a DHCP server by enabling DHCP (option 9.1)
• Manually set the address using the Non DHCP Subnet Mask option (Option 9.9)
9.6 Current Gateway
Shortcut: Setup, 9, 6 save
To view the Current Gateway, press 6 on the Network menu, or scroll down to highlight Current
Gateway and press the select soft key.
The Current Gateway is set in one of the following ways: