Life Fitness OHDHR - Manual (Page 10)

10
STEP 7:
FIGURE 7
• LOOSELY assemble one RIGHT & one LEFT ADJUSTMENT RACK (9 & 10) to the REAR UPRIGHTS (4) as shown, using eight
3/8 X 3-3/4” FLAT HEAD BOLTS (17), eight 3/8” INT TOOTH LOCK WASHERS (20) and eight 3/8” LOCK NUTS (23). See FIG-
URE 7.
23
3/8 X 3-3/4” 17
20
9
10
4
4
13
12
• Before tightening the ADJUSTMENT RACKS (9 & 10), slide the LEFT and RIGHT BAR SUPPORTS (12 & 13) over the ADJUST-
MENT RACK and REAR UPRIGHT. Assemble one BAR SUPPORT close to the top and the other close to the bottom, as shown
in DETAIL 7. (Make sure not to cover any bolt heads.) Proceed to tighten all four bolts in the order shown in DETAIL 7. Repeat
this step on the remaining ADJUSTMENT RACK.
SETTING ADJUSTMENT RACK WIDTH (SEE DETAIL 7)
DETAIL 7
10
4
1
3
4
2