Lowrance electronic iFINDER GO - Manual (Page 68)

62
2. Set S PEED
to zero. Select S TEER WITH A RROWS
command and press ENT ,
which turns on the simulator and returns you to the Map Page.
3. Begin navigating along the trail/route. (If you are close enough to the
first waypoint, the arrival alarm will usually go off as soon as naviga-
tion begins. Press
EXIT to clear the alarm.) When navigation starts,
press
↑ (since you're using the Simulator's
S TEER WITH A RROWS
command)
to increase speed to the desired setting.
4. Press EXIT to turn off the steering and speed boxes. The unit will now
automatically "steer" along the trail or route. When you arrive at your
"destination," cancel navigation as you normally do.
Map Auto Zoom
This receiver has an auto zoom feature that eliminates much of the but-
ton pushing that other brands of GPS receivers force you to make. It
works in conjunction with the navigation features.
First, start navigation to a waypoint. (See the waypoint section for
more information on navigating to a waypoint.) Then, with the auto
zoom mode on, the unit zooms out until the entire course shows, from
the present position to the destination waypoint. As you travel toward
the destination, the unit automatically begins zooming in — one zoom
range at a time — always keeping the destination on the screen.
To turn this feature on, from the M
AP
P
AGE
, press MENU |
↓ to
A
UTO
Z OOM
| ENT . Repeat these steps to turn it off.
Map Data
This menu lets you turn the map off, if desired (which turns the map
screen into a GPS plotter) or choose another level of map detail; turn off
or on the pop-up map info boxes; or fill land areas with gray. You can
also turn on or off Map Overlays, which display latitude and longitude
grid lines or range rings on the map.
To get to Map Data:
1. From the Map Page, press
MENU |
↓ to
M
AP
D
ATA
| ENT .