Lexmark 2400 - Manual (Page 17)

17
Setting Top-Of-Form for a cut form or envelope
Top-Of-Form can range from minus 1 to plus 22 inches from the top of cut
sheet paper.
1 Press FormFeed to clear paper path.
If the Paper Out light is Off, tear off excess forms and press Load/Unload.
2 Move paper select lever to the cut forms.
3 Load a cut sheet of paper or envelope through the manual feed door.
4 The printer moves the paper or envelope to the current Top-Of-Form, if
Auto Cut Sheet is set to On.
If not, press FormFeed when the Paper Out light goes Off.
5 Open the operator panel to layer 2.
6 Press any paper movement button (LineFeed, Micro
↑
, Micro
↓
) to align
the Top-Of-Form you want with the horizontal lines (located on the platen).
7 Press Set TOF to set and save Top-Of-Form.
8 Close the operator panel cover.
9 Press Start/Stop to put the printer online.
Changing from continuous forms to a cut
sheet or envelope
Load/Unload parks (unloads) continuous forms so you can insert a cut
form or envelope into the manual feed door to print or load paper to the
current Top-Of-Form.
1 Make sure the tractor unit is in the push position.
2 Tear off the continuous form at the perforation.
3 Move the paper select lever down to continuous forms.
4 Press Load/Unload.
The continuous form paper moves out of the paper path. The Paper Out
light blinks and the paper out alarm sounds.
5 Move the paper select lever up to cut forms.