Lucent Technologies Network Access Module - Manual (Page 46)

Selecting PMVision Functions
6-6 INA Module Installation and Configuration Guide
Ether0 netmask INA
→
Configure
→
Ethernets,
Edit
IP netmask
System name INA
→
Configure
→
SNMP System name
Default gateway INA
→
Configure
→
Global IP gateway
Name service type INA
→
Configure
→
Global Name service
Name server address INA
→
Configure
→
Global Primary name server
WAN port address INA
→
Configure
→
Ports, Sync
ports, Edit
Local IP address
Remote router address INA
→
Configure
→
Ports, Sync
ports, Edit
DestinationIP
address
Remote router
netmask INA
→
Configure
→
Ports, Sync
ports, Edit
Netmask
Channel rate INA
→
Configure
→
Lines,
line0,
→
Edit
→
Groups
→
Edit
Rate, Save
Protocol INA
→
Configure
→
Ports, Sync
ports, Edit
PPP or Frame
DLCI list source
(Frame Relay only) INA
→
Configure
→
Ports, Sync
ports, Edit
Keep Alive
LMI, Annex-D or
manual
DLCI Keepalive Value
(Frame Relay only) INA
→
Configure
→
Ports, Sync
ports, Edit
Keepalive interval
DLCI list (Frame Relay
only) DLCI number, IP
address
DHCP server address INA
→
Configure
→
DHCP Select the checkbox
to enable
DHCP lease time INA
→
Configure
→
DHCP Lease
DHCP static binding IP
addresses and
corresponding MAC
addresses INA
→
Configure
→
DHCP
→
Bindings
→
Add
IP address, MAC
address
DHCP address pool
start address and end
address INA
→
Configure
→
DHCP IP pool addresses
Table 6-1 Basic INA Module Configuration Using PMVision (Continued)
Setting Select PMVision Function: Entry