Lucent Technologies Network Access Module - Manual (Page 74)

Index
Index-4 INA Module Installation and Configuration Guide
Point-to-Point protocol. See protocol, WAN port
PPP. See protocol, WAN port
precautions, safety ix
print reports C-8
protocol, WAN port 2-3 , 5-7 , 6-6
R
reboot button, location 1-4
removing data channels C-3
renumbering boards C-8
reports C-8
restoring
INA module settings 6-8
MERLIN MAGIX settings C-7
running PMVision 6-2
S
safety instructions ix
selected interval events C-5
serial passthrough
connecting 3-1
using 5-2
set administrative password 5-2
set broadcast address 5-3
set channel rate 5-6
set default route gateway 5-4
set DIP switch 1 to the right. 3-2
set DIP Switches 3-2
set domain 5-5
set Ether0 broadcast 5-3
set Ether0 netmask 5-3
set gateway 5-4
set line0 channels 5-6
set nameserver 5-5
set namesvc 5-5
set system name 5-4
settings
INAWizard 2-3
using PMVision for 6-5
set W1 address 5-7
set W1 destination 5-7
set W1 netmask 5-7
set W1 protocol 5-7
set W1 speed 5-6
slot busy out C-8
SPM. See WinSPM
subnet mask 5-3 , 5-7
support, technical xiv , xv
surrogate operation C-7
system erase C-9
system interactions C-7 , C-8
system LED
location 1-3
observing 3-5
system name 2-3 , 5-4 , 6-6
system requirements
INAWizard 4-1
PMVision 6-1
system restart C-9
T
T1/PRI
all unequipped 2-2 , C-2
assign channels 2-2 , C-2
assigning channels 2-2
cable B-2
connector location 1-4
LEDs 3-4
MERLIN setup 2-1
provisioning information 2-1
unequipped 2-2 , C-2
tables, configuration 6-5
technical support xv
telnet console session 5-2
test jacks, DS-1
location 1-4 , A-7
using A-5
tests
BERT C-6
line loopback C-6
payload loopback C-6
training
INA module xv
PortMaster xv
transport protocol. See protocol, WAN port
troubleshooting INA module
A-1
U
unassigning data channels C-3
using INAWizard 4-1 , 6-1
using WinSPM 5-2
V
voice channels, description 1-1