LG BG-81A - Manual (Page 6)

— 6—
2.1 MECHANICAL PARTS
2.1.1 FRONT GRILLE
1. Open the inlet grille downward.
2. Remove the screw which fastens the front grille.
3. Pull the front grille from the right side.
4. Remove the front grille. (See Fig. 1)
5. Re-install the component by referring to the
removal procedure.
2.1.2 CABINET
1. After disassembling the FRONT GRILLE, remove
the 6 screws which fasten the cabinet at the both
sides and the top. (See Fig. 2)
Keep these for later use.
2.1.3 CONTROL BOX
1. Remove the front grille. (Refer to section 2.1.1)
2. Remove the screw which fasten the control
box. (See Fig. 3)
3. Pull the control box from the barrier.(See Fig.3)
4. Discharge the capacitor by placing a 20,000 ohm
resistor across the capacitor terminals.
5. Disconnect two wire housings in the control box.
6. Pull the control box forward completely.
7. Re-install the components by referring to the
removal procedure. (See Fig. 3)
(Refer to the circuit diagram found on pages
2 6 in
this manual and on the control box.)
2. DISASSEMBLY INSTRUCTIONS
— Prior to disassembling the unit, make sure that the POWER is off and the power cord is unplugged from the
wall receptacle.
MO DE TIM ER
PO WE R
FA N SPEED
Fan
Ene rgy Save r Coo l
Tim er TEMP 'F F1 L OW F2 ME D F3 H IGH
Figure 1
Figure 2
MODE
TIMER
PO WER
FAN SPE ED
Fan
Ener gy Sa ver
Coo l
Tim er TEM P
'F
F1 L OW F2 M ED F3 H IGH
MO DE TIM ER PO W ER FA N SPEE D Fa n En erg y Sa ve r Co ol Tim er TE MP
' F F1 LO W F2 M ED F3 HI GH
MODE TIMER POWER FAN SPEED
Fan Energy Saver Cool
Timer TEMP
'F F1 LOW
F2 MED
F3 HIGH
Figure 3