Lantronix Ethernet - Manual (Page 54)

Setup Mode: Channel Configuration
WiBox2100E User Guide 54
a) Incoming Connection
Never Accept Incoming Rejects all external connection attempts.
Accept with DTR Active Accepts external connection requests only when the DTR input
is asserted. Cannot be used with Modem Mode.
Always Accept Accepts any incoming connection when a connection is not
already established. Default setting.
b) Response
Character Response A single character is transmitted to the serial port when there is a
change in connection state:
C = connected, D = disconnected, N = host unreachable.
Single character mode specifies the character response. The IP
address of the host connecting to the unit displays when the unit
is in verbose mode. This option is overridden when the Active
Start Modem Mode
or Active Start Host List is in effect.
Default setting is Nothing (quiet).
c) Active Startup
No Active Startup Does not attempt to initiate a connection under any
circumstance. Default setting.
With Any Character Attempts to connect when any character is received from the
serial port.
With DTR Active Attempts to connect when the DTR input changes from not
asserted to asserted.
With a Specific Start
Character Attempts to connect when it receives a specific start character
from the serial port. The default start character is carriage return.